Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.ģV2032 Lithium battery. Tested to Comply with FCC Standards FOR HOME OR OFFICE USE. THERE ARE NO OTHER USER SERVICEABLE PARTS. ![]() NOTICE: To comply with FCC and or Industry Canada (IC) rules, adjustment or modifications of this receiver and/or transmitter are prohibited, except for changing the code setting or replacing the battery. Insert new batteries positive side up (+). ![]() To replace the batteries, remove the two screws and the logic board from the plastic housing, as shown. The lithium batteries should produce power for up to 5 years. If battery is swallowed, immediately notify doctor.NEVER allow small children near batteries.To prevent possible SERIOUS INJURY or DEATH: DO NOT overtighten, you may damage the plastic housing. Position bottom of door control on screw head and slide down to secure.Drill pilot holes and install bottom screw, allowing 1/8" (3 mm) to protrude above the wall surface.Fasten with 6ABx1-1/4" self-tapping screws as follows: Remove the push button cover by gently prying off the top edge with a screwdriver. NOTE: Locate the door control within sight of the door at a minimum height of 5' (1.5 m) where small children cannot reach and away from all moving parts of the door and door hardware. The opener lights should turn on or off but the door should not move. Test by pressing the Light button on the wireless control panel. After the opener lights flash, release all buttons. Press and hold the Lock button on the multi-function control panel.Ĥ. Press and hold the Light button on the multi-function control panel.ģ. With the door closed, press and hold the Light button on the wireless control panel.Ģ. A wired multi-function control panel is required to program the Light button on the wireless control panel.ġ. With 315MHz Security ® wireless control panel, the Light button can be programmed to operate the opener lights without opening the door. NOTE: Feature not available with universal receiver. Reprogram each remote or keyless entry you wish to use. Press and hold the “Learn” button on motor unit until the learn indicator light goes out (approximately 6 seconds). To deactivate any unwanted remote, first erase all codes: To Erase All Codes From Motor Unit Memory If light bulbs are not installed, two clicks will be heard. ![]() Hold the Settings button down until the LiftMaster myQ Smart Garage Control beeps once more. Release the button when the motor unit light blinks. Reset to factory settings if the blue LED still does not blink: Press and hold the Settings button for roughly 10 seconds, or until the blue LED blinks, then release. Large push button or auxiliary button on theģ. Within 30 seconds, press and hold either the Press and release the “Learn” button on the Select large push button for the primary opener and use the auxiliary button for the You can use the wireless control panel to control up to two seperate garage door openers. There is no constant pressure to override The Protector System® in an emergency.Īlso known as: 012381993789, 378LMC IMPORTANT: Due to supply chain shortages we currently do not offer quantity discounts, and for some of our products we are limiting the quantities that may be purchased.To Program The Large Push Button or Auxiliary Button To A Garage Door Opener
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |